The Premier 90 is a vintage tube-based reverb using a full-length reverb tank. This one is in great cosmetic condition. I found this in non-working condition. These were fairly primitive units for their day and used a carboard mulit-capacitor can that almost always dries out after so much time, causing complete, noisy failure - and that was the case here. My strategy with these is to replace that can with a separate circuit board mounted with high-voltage Nichicon replacement caps and put that board in a heavy duty plastic enclosure. The enclosure is velcro'ed to the inside of the case for easy removal. The Premier 90 comes with a remote effect on/off footswitch which is hard-wired to the chassis. The wire on this one was super worn and cracked open in a few places so I replaced the wire and added a right-angle jack on the end, then installed a jack inside the storage compartment for connecting the footswitch. Much more convenient. Also lets you use the footswitch for other applications if desired (latching footswitch here). Now, this is working great. No more hum or electrical noise. Very easy to dial in some sweet reverb from very mild to that vintage under water sound. The volume knob is meant to dial in your unity volume, and the intensity knob increases the amount of reverb that gets mixed in.