This is not an everyday speaker selector. It is a professional 10 pair component with dual amplifier selection and impedance matching.
This unit also includes ALL of the Snap Connectors on the back. Many of these are missing connectors and they're expensive to replace.
Here are the specs and features:
The Russound PRO-10 is a legacy 10-pair, dual-source impedance-matching speaker selector from Russound’s PRO Series, built to safely distribute stereo audio from one or two amplifiers across up to 10 zones simultaneously.
Key Features
• 10-Pair Zone Control. Individual front-panel push buttons let you turn up to 10 pairs of speakers on or off in any combination.
• Dual-Source Switching. A front-panel AMP A / AMP B selector button switches all active zones between two separate stereo amplifiers.
• Selectable Autoformer Impedance Matching. Internal audiophile-grade autoformers and a rear-panel rotary switch (SPEAKER PAIRS) prevent your amplifier's impedance load from dropping too low when multiple rooms play at once.
• Low-Frequency Protection Circuit. A built-in bipolar capacitor high-pass filter cuts subsonic frequencies to prevent amplifier clipping and shutdown at higher volumes.
• Installer-Friendly Wiring. Includes detachable 4-pole color-coded snap connectors, isolated left and right channel grounds (safe for bridged or floating-ground amplifiers), and printed room labels.
Technical Specifications
According to the Russound PRO Series Manual, the PRO Series chassis shares the following core specs:
• Power Handling. 100 watts RMS continuous per channel (200 watts average, 300 watts peak).
• Amplifier & Speaker Compatibility. Supports 4-ohm or 8-ohm amplifiers and 4-ohm to 8-ohm speakers.
• Frequency Response. 20 Hz to 20 kHz.
• Low-Frequency Filter. 6 dB high-pass filter centered at 30 Hz.
• Maximum Wire Gauge. Accepts up to 12 AWG speaker wire (newer PRO-HP revisions specify 14 AWG).
• Chassis Dimensions. 17" W × 2.875" H × 8.25" D (43.2 × 7.3 × 21 cm).
• Weight. Approximately 7.8 to 8 lbs (for reference, the PRO-8 is 7.75 lbs and the PRO-12 is 8.0 lbs).
Rear Rotary Switch Setup
To protect your amplifier, set the rear SPEAKER PAIRS rotary dial based on the total number of speaker pairs wired to the unit rather than how many are turned on at a given moment:
• 8-ohm amp + 8-ohm speakers (or 4-ohm amp + 4-ohm speakers). Set the dial to the exact number of connected speaker pairs.
• 8-ohm amp + 4-ohm speakers. Set the dial to twice the number of connected speaker pairs.
• 4-ohm amp + 8-ohm speakers. Set the dial to half the number of connected speaker pairs.