loading
reading
writing
saving
searching
Plasma table complete operation... - $10,500 (Toms Rive)
condition:
new
QR Code Link to This Post
Everything is brand new, unused, stored in a climate-controlled shop.
New, over $15,000 in parts, I did all the hard work so you can use it!
Asking $10,500 ORO for everything,
STV CNC Sparx Pro8
-4x8 Plasma cutting water table, heavy duty fully welded frame
-Por15 coated welded water pan
-3:1 gear reduction and cable management
-Torch Height Control
-Magnetic breakaway
-Collision, Ohmic and Material detection sensors
-Auto-homing kit
-32" Vizio Monitor
-Monitor and laptop holder mounted to table
-Wireless video game controller to move gantry remotely
Water Table Drain and Filter system installed
-75 Gallon RV water storage tank (saves on water/additive evaporating between uses)
-3 each drains welded into pans with screen traps
-PVC plumbing with quick disconnects everywhere for servicing
-Whole house water filter system
-heavy duty raised (¾” plywood & 4x4) platform for water tank (allows for 8’ long steel tubing storage underneath)
-115VAC water pump and hose to refill table from storage tank
-Extra whole house filter cartridge
Water separator/filter/dryer
-Multiple hose inputs from air Compressors for max flow
-Check valves for single compressor isolation
-Built in Pressure regulator
-Built in whip to Ref Air Dryer unit
Hypertherm Powermax65 SYNC Plasma Cutter
-25’ machine torch
-25’ ground clamp
-5/8” pierce
-SYNC cartridge reader included
-Extra SYNC cartridges (NEW)
Ingersoll Rand Refrigerated Air Dryer