loading
reading
writing
saving
searching
Miller AEAD-200LE Engine-Driven Welder+Oxy-Acetylene Rig+Angle Grinder - $800 (Ravenna)
NE 72nd St near 28th Ave
QR Code Link to This Post
Selling my late father's welding setup. He was meticulous about maintaining his equipment, and everything here was well cared for and stored properly — but it's been sitting unused for a few years, so I'm selling it as-is.
Included:
- Miller AEAD-200LE AC/DC engine-driven welding generator (Model AEAD-200LE, Serial HH022754) — powered by an Onan CCKA-MS/2748J gas engine, mounted on the original wheeled cart
- Full set of welding leads with stinger/electrode holder and ground clamp (2 sets shown, ~40+ ft)
- Oxy-acetylene cutting/welding rig — cart with oxygen and acetylene tanks, dual regulators/gauges, cutting torch, and both hoses
- Angle grinder set - Dewalt 4.5 inch disc angle grinder with a good number of angle grinding discs (not pictured, happy to send photos on request)
Condition: As-is / untested — this hasn't been run in a few years. The 12V battery is almost certainly dead and will need to be replaced before starting the engine. I have not tested the oxy-acetylene tanks/gauges either. That said, everything looks clean and well-maintained (no rust-through, gauges and hoses intact), consistent with how carefully it was kept. Buyer welcome to inspect before buying.
From the ID plate: AC/DC output up to 225A, oil capacity 3.5 qts, 12V system.
Price: $800 OBO for everything — welder, cart, leads, full oxy-acetylene rig, and grinders. Priced to reflect the whole bundle, not just the welder.
You pickup