28" Troy Built 3 stage snow blower with snow shield. Also installed an old snowmobile headlight which is much brighter than stock head light. Stock headlight is still there, you just need to remove the bigger light. It worked good for me when I needed to blow snow early to get to work. I'm retired and am 74 years old and in deep snow it is hard for me to handle. I was going to add a blower and cab to a lawnmower but converting it would be to much for me to do. I purchased a new Ariens with a track which is suppose to be much easier to handle. One thing the 3 stage is really superior when it comes to heavy wet snow. Once it wasn't working but on checking the inner auger's pin was sheared. Other wise no problem I have had a Craftsman, old Ariens and Simplicity which were two stages which would pack wet snow in the shut and plug. I never had problems with the 3 stage doing that in fact with two inner augers spinning madly it would sometimes come out as water. But never plugged. I have only sheared one pin in the 10 years of owning the blower which looks fairly new, but we haven't had a lot of snow for all those years. I do have extra shear pins also. I did wield a stainless scraper blade which can be just unbolted and you can purchase a new steel one. But a stainless steel one should last much longer than buying one. It does have electric start and electric hand warmers. The motor is a 357cc which is around 13 HP and extra wide tires. Asking 450 or best offer.