loading
reading
writing
saving
searching
Drill Press - $200 (Melbourne)
Florida Ave near Purdue
QR Code Link to This Post
Kept inside for years, so in good condition - clean
5/8" capacity chuck, Morse taper. Chuck removal wedge included.
32 inch tall, ~ 22 inch deep. Table is 12 inch round.
Solid build - very stable. Not sure of weight, but I can't lift it. Takes two men to move, one of them not me!
Table rotates 360 degrees and locks in place with clamp.
Table mount also adjustable to kick off 45 degrees left or right.
Belt drive, multi speed adjustable.
Unable to read plate on motor, but I'm guessing 3/4 hp.
Table can be rotated completely out of work area for work on large pieces.
I'll also include a drill press vise (Craftsman) that is pretty handy. (Not shown in photos)
This machine is solid. Check it out.