loading
reading
writing
saving
searching
AMC 1970-73 AMX, Javelin Clutch Adjusting Rod with Foam Seals - $55 (Richfield, WI)
QR Code Link to This Post
$55 plus shipping
Colgate, WI
1970-73 AMX, Javelin, Hornet, Gremlin, Rebel, Rebel Machine, Ambassador --- Clutch Adjusting Rod for Throwout Lever with Plastic Tip and Foam End Seals.
Brand new, reproduction Clutch Rod with Plastic Tip for Throwout Lever.
The part was blue printed, designed, and machined in the USA.
The main adjusting threaded rod is made out of a single piece of steel.. The plastic tip was made out of the same material as the original part (Nylon).
Included with this set is the adjusting threaded rod, trunnion, the plastic tip and a pair of foam end seals. Small parts include two jam nuts, one wave washer, one steel washer, and the hairpin clip.
- Complete assembly measure approximately 7" end to end
- Threaded rod is about 6-7/16" end to end
The complete assembly will fit the following models:
- 1970 Rebel, Rebel Machine, AMX and Javelin (Left Hand Drive, V8 with 4 speed transmission)
- 1970 All models (Left Hand Drive, V8 with 3 speed transmission)
- 1970 Hornet and Gremlin (Left Hand Drive with 199 Engine)
- 1971 Hornet SC/360 (Left hand drive with 360)
- 1971 Matador, Javelin, Javelin AMX and Ambassador (Left hand drive)
- 1972 Matador, Javelin and Ambassador (Left hand drive)
- 1972 Javelin, AMX (V8)
- 1972 Hornet, Gremlin (Left Hand Drive, Six Cylinder Engine)
- 1973 Hornet and Gremlin (Left hand drive with Six Cylinder Engine)
- 1973 Javelin and Javelin AMX with V8