Blacksmith/Coppersmith/Sheetmetal Pexto Anvil Type Andirons - $500 (Pinellas)

Blacksmith/Coppersmith/Sheetmetal Pexto Anvil Type Andirons 1

QR Code Link to This Post

I have a small set of Pexto or Tinsmith type anvil mount andirons for sale, consisting of different configured heads, all which have a taper support stems that fits a standard Hardy hole in a anvil or a Pexto table plate. These may be 100 years old or older as the barn I found them in was constructed in roughly 1892. Will ship for actual added cost once your zip code is established if needed. Both square/round/taper/shoe type andirons. This smaller set has tapered mount stems that will fit a standard anvil Hardy hole (approximately 7/8" to 1" square hole). All that is pictured can be purchased for $500, minus the hinge splitter which has already been sold.

Note that I will split out individual items for the following prices;
25" larger/longer units are $90 each.
20" smaller/shorter units are $75 each.
Hinged splitter/cutter is $125. This items has been sold.
T bar splitter/folder is $100.
Smaller elevated stem anvil is $75.

I also have a Pexto table plate that can be had (BUT ONLY WITH PURCHASE OF ALL ANDIRONS HEREIN LISTED) for an additional $250.

I just discovered PICARD supply for the same items I have herein advertised, and WOW am I under priced as to the value for these items. Most are at least 3 to 4 times the cost I have listed.

NOTE: IF WHAT YOU ARE LOOKING FOR IS NOT HEREIN ADVERTISED, I DON'T HAVE IT, SO STOP ASKING FOR SOMETHING/ANYTHING NOT ADVERTISED IN THIS AD.

NOTE NO TRADES, all sales final, all sales cash only. Location Pinellas County Florida

do NOT contact me with unsolicited services or offers

post id: 7981109448

posted: 2026-10-10 07:09

updated: 2026-10-20 08:02

♥ best of ^[?]

reading

writing

saving

searching

refresh the page.

Blacksmith/Coppersmith/Sheetmetal Pexto Anvil Type Andirons - tools...