Originally Posted: 2012-03-19 21:26 (no longer live)
print

Star Wars TIE Fighter

Have the coolest toy in your neighborhood! Approximately 1/3 scale TIE Fighter. 8x8x8 feet but breaks down into 5 pieces for easy transport in a pickup or can haul partially assembled (except for the top half of the wings) on a trailer. Wheeled casters make it easy to move once assembled. Laser cannons are set to fire standard party poppers. Well built out of 3/4 plywood with the wings sheeted in cardboard. Tested to hold over 300 pounds. Cockpit is 38 inches by 38 inches and my 5ft tall son comfortably sits inside. $150 or best offer *SOLD* 3/21

I've had hundreds of calls, texts and e-mails. For those of you that asked: I built it for our Church's AWANA annual Drive-Inn movie night. It is a father/child project where the younger kids take cardboard and build a "car" to sit in and eat popcorn and watch a movie. We kind-of go over the top every year. We built an X-Wing 2 years ago so we needed a Tie Fighter. I didn't have plans, just a sketch pad and ideas in my head. I used this to teach my 9th grader how to use the Pythagorean Theorem and get some practical application to algebra as helped build this for his younger siblings. All the edges to the body panels are 22.5 degrees. The main panels are 16x24, the front and rear panels off those are 16x12, all ¾ birch plywood. The wing struts are boxed 8 inches wide, ¾ plywood, 30 inches long. They are attached with Simpson 90 degree gussets and re-enforced with 2x2s. The lower half of the wings are 2x4 sheeted in cardboard. The upper half are 1x2 sheeted in cardboard. The wing to strut connection is a compression fitting design. If you want more detailed photos to build your own I'll e-mail them.

  • Location: Olympia
  • it's NOT ok to contact this poster with services or other commercial interests


image 0

image 1

image 2

image 3

post id: 2911685977